Welcome Guest! To enable all features, please Login or Register.



Last Go to last post Unread Go to first unread post
#1 Posted : Tuesday, June 19, 2007 12:31:57 PM(UTC)

Groups: Registered
Posts: 23

I currently have b/w tiff's that sometimes have lots of dots noise which I need to clean up before I OCR. Problem is if I remove dots on image w/o the noise it removes valid dots as in :;.i! etc. I would like to know if there is a way to check a page to see the level of noise and if over 50% then I can run dotremove else don't run. Just wondering if there is some way to do this.


Try the latest version of LEADTOOLS for free for 60 days by downloading the evaluation: https://www.leadtools.com/downloads

Wanna join the discussion? Login to your LEADTOOLS Support accountor Register a new forum account.

#2 Posted : Wednesday, June 20, 2007 12:40:00 AM(UTC)

Qasem Lubani  

Groups: Guests
Posts: 3,022

Was thanked: 2 time(s) in 2 post(s)

There is no function
in LEADTOOLS to estimate noise level, but you can perform dot removal and
restrict the effect to dots smaller than specific dimensions. This way, larger dots such as : and ! are not affected.
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET
This page was generated in 0.039 seconds.