Using the Automation Editing Capabilities

Start with the project you created in Using the Undoing/Redoing capabilities.

1. Add the following menu structure to the Edit popup menu you created in Using the Undoing/Redoing capabilities after the &Redo item:

    Cu&t     with ID = IDM_EDIT_CUT 
    &Copy    with ID = IDM_EDIT_COPY 
    &Paste   with ID = IDM_EDIT_PASTE 
    &Delete  with ID = IDM_EDIT_DELETE 

2. Add the following lines to the WndProc after the statement "return 0L ;" of the case IDM_EDIT_REDO in the WM_COMMAND message:

   case IDM_EDIT_CUT: 
   // Cut the current selection to the clipboard 
   L_AutCut(pAutomation, 0); 
   return 0L; 
   case IDM_EDIT_COPY: 
   // Copy the current selection to the clipboard 
   L_AutCopy(pAutomation, 0); 
   return 0L; 
   case IDM_EDIT_PASTE: 
   //check if there is a valid automation mode data on the clipboard 
   L_AutClipboardDataReady(pAutomation, &fState); 
   if (fState) 
   { 
      // paste the data to the current active container 
      L_AutPaste(pAutomation, 0); 
   } 
   return 0L; 
   case IDM_EDIT_DELETE: 
   // Delete the current selection 
   L_AutDelete(pAutomation, 0); 
   return 0L; 

3. Compile and run the project by selecting Build->Execute tutorial.exe from the menu.