Problem when drawing shapes

Hi,
   I am using leadtools version 16 in my desktop application. When I tried to draw shapes using the same codes that you were used in 'DrawDemo', shapes are not drawing properly..
 I used this code
 using (Pen pen = new Pen(clsVariables.penColor,clsVariables.penwidth))
                                    {
                                       container.Graphics.SmoothingMode = SmoothingMode.AntiAlias;
                                       container.Graphics.DrawPath(pen, path);
                                         }
 when I tried to draw rectangle with a width less than 4 some sides are not drawing...(some time drawing properly, some time not).It drawing properly when width is greater than 4..How can I solve it?

Regards,
ssskkk

Can you please try to isolate the problem in a very small test project (not your full application) and send it to me in a ZIP or RAR file? If you don't want to post it here, you can email it to support@leadtools.com.

Hi,
     I attached my sample solution with this, In this application I set pen width to 1,then some sides not drawing..

Regards,
 ssskkk
 

You are zooming out and using the Fit SizeMode. This can cause pixels to disappear. To solve that change the PaintDisplayMode to Resample as follows:
In the Form1_Load function add this code:
RasterPaintProperties pp = rstrDualImg2.PaintProperties;
pp.PaintDisplayMode = RasterPaintDisplayModeFlags.Resample;
rstrDualImg2.PaintProperties = pp;

Hi, I added that extra code and drawing shapes are working properly, but when I use zoom to rectangle and tried to zoom the canvas again and again an exception is coming that is "Not enough memory available." I can't handle it by using try.. catch block.. How can I handle it?

Regards,
ssskkk

If you are sure you're not trying to zoom to a zero-width or zero-height rectangle, please create a new forum post or open a new support ticket by emailing support@leadtools.com, since this appears to be a different issue not directly related to this thread.